![]() ![]() If you attempt to install OpticsBuilder on Creo Parametric versions between 7.0 and 7.0.4, you will see a pop-up message instructing you to upgrade to Creo Paremetric 7.0.5.0 or later. What it's About This webinar will provide an overview of PTC Creo Parametric and how it enables engineers to reach their product development. This bug affects OpticsBuilder’s ability to run properly and may result in the add-in not being available, import issues, and/or other functionality problems. In general we recommend to use OpticsBuilder with Creo Parametric 7.0.5.0 and later, due to a bug found in PTC Creo Parametric versions earlier than 7.0.5.0, OpticsBuilder will not work properly when installed on versions between 7.0 and 7.0.4. Please follow the instruction on the warning message in order to solve this issue or refer to prior chapter (Step 6) Additional Information Make sure that the "Legacy Toolkit Application Runtime" is checked in "Customize Application" window.Īfter that, please click "Install" in order to be able to load OpticsBuilder successfully.Application Selection should remain as it is.License identification should remain as it is.In order to solve this please follow the listed steps below: When loading OpticsBuilder in Creo Parametric 7.0.5.0 and later, the following error message might occur: However, we do recommend to use OpticsBuilder within Creo Parametric 7.0.5.0 and later, the reason for that is elaborated in Chapter: Additional information. ![]() It is differ from AutoCAD in such a way that it is based on Parametric which. Please only apply them when you encounter any of the mentioned warning messages. Creo Parametric is a cad-cam software widely used for product design and assembly. Creo has been the standard product design and development software for parametric modeling, simulation/analysis, and product documentation for 30 years. Some user might have these preconditions set per default and therefore do not have to apply these troubleshooting steps. When loading OpticsBuilder within Creo Parametric 7.0.5.0 and later, some preconditions have to be set in order to run the OpticsBuilder Add-in smoothly. OpticsBuilder is currently available for Creo 4, 5 and 6 and with OpticsBuilder 22.1 (Release: February 1st 2022) also for Creo Parametric 7. This article describes the steps which can be taken in order to troubleshoot potential application issues when Zemax OpticsBuilder fails to load in Creo Parametric 7.0.5.0 and later.
0 Comments
Leave a Reply. |